V-STRIKE® Coil Cleaning

 Improves Indoor Air Quality by Destroying Surface Microbes that Grow on Coils


 V-STRIKE® Coil Cleaning System

• Helps reduce colds, flu and other viruses

• Waterproof NEMA-3 design for outdoor locations

• Easily installs into "through the wall" or "rooftop"

• Produces no ozone, gases, or other noxious fumes 

• Will not harm building occupants, equipment or furnishings

• Heavy gauge steel, tamper-resistant enclosure


UVDI’s coil cleaning systems are designed to meet or exceed ASHRAE Guidelines.

 Tech Specs


The UV-C lamp and fixture are factory assembled and tested. They consist of a housing, power source, lamp sockets and a UV lamp. All components are constructed to withstand typical HVAC environments. They are UL/C-UL Listed under category Code ABQK (Accessories, Air Duct Mounted), UL Standards: 153, 1598 and 1995.

The housing is constructed of type 16 gauge, powder-coated steel and is equipped with 3/4" electrical knockouts on all accessible sides to facilitate wiring to A/C power. Fixtures may be used as side (XS) or top (XT) mount as required or as shown on the plans. Each fixture incorporates all components into one integral assembly that maximizes service-ability. Fixtures shall be designed to be mounted outdoors or where necessary.


The power source is an electronic, high frequency, rapid-start type with overload protection.  Its standard power switching capability allows for 120 VAC/240 VAC wiring and is designed to maximize photon production, radiance and reliability and is UL/C-UL Listed for temperatures of 55°F — 135°F (13°C — 57°C). It includes exclusive RF and EMI suppression.


UV Lamps and Mounting

The UV lamps are mounted in a sturdy and easy to handle assembly which mounts quickly (1/2) turn into a specially designed socket within the enclosure. An integral plug provides power. This provides a very sturdy mount that allows for quick lamp changes.

UV lamp and connector are integrated into one unit that includes a steel support to protect the lamp before, during and after its installation and operation. The bayonet style lamp includes a rotational mounting and locking connector knob (with light pipe) that accepts lamp power via a safety plug from the power source. The lamps 0 medium bi-pin type for the VS-32-T5 and VS-28-T5. The VS-15-PLL type is a bi-axial, T5 diameter twin-tube type. Both lamps have their pins isolated from the air stream. Each achieves the specified output at 500 fpm in air temperatures of 55°F — 135°F (13°C — 57°C). They produce no ozone or other secondary contamination.

Regulatory Approvals

  • ETL listed to UL/Canadian standards:
  • UL 1598/CSA 22.2 250
  • UL 1995/CSA 22.2 236
  • UL 153/CSA 22.2 12 for category ABQK (Air Duct Mounted Accessories)